Martin Audio W3 Spezifikationen PDF herunterladen (Seite 9)

Plug-in board jumper link positions are as follows:

Jumper Position Jumper Position

Mode (1), Full Range J4/J5 B J1/J7 OUT

J3/J6 A J2/J8 OUT

Mode (2), 100Hz high-pass J4/J5 A J1/J7 IN

J3/J6 B J2/J8 IN

Mode (3), Overlap J4/J5 B J1/J7 IN

J3/J6 A J2/J8 IN

6.4 W1, W2, W3 Passive Operation Using WX3ASF Card (Stereo)

A WX3A controller is used to provide LF equalisation and limiter functions

for stand-alone W1, W2 and passive W3 systems operated full-range (see

Fig 7). In this instance the W1, W2 and W3 should be driven from Bands 2

and 4 set to operate in full-range Mode (1) (see Section 6.3).

6.5 W1, W2, W3 Passive with Sub Bass Operation

Using WX3ASF (Stereo)

The WX3ASF may also be used to drive a sub-bass system to augment the

W1, W2 and passive W3 systems (see Fig 8). The WX3A is normally

operated in 100Hz high-pass/crossover Mode (2) (see Section 6.3) for this

configuration, although it may be operated in Overlap Mode (3) if overlap is

required for flown systems. Full-range Mode (1) should only be used with

care, in special cases where distant flown systems are required to run full-

range. Some cancellation may occur if the W1, W2 and W3 are located in

close proximity to the sub-bass enclosure. However, this cancellation may

simply be resolved by reversing the phase of the W1, W2 or W3.

Martin Audio – WX3A System Controller

ENGLISH

LEFT

INPUT

RIGHT

INPUT

NOT

USED

F.R.

NOT

USED

F.R.

W2 PASSIVE

W3 PASSIVE

W2 PASSIVE

W3 PASSIVE

Fig 7. W1, W2 or W3 Passive operation using WX3ASF Card

CONTENTS

GUIDES

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Martin Audio W3 Spezifikationen Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Equalizer Martin Audio W3