Martin Audio W3 Spezifikationen PDF herunterladen (Seite 8)

6.3 WX3A - Sub Bass and Full Range/High Pass

Configuration (Stereo)

The WX3ASF plug-in board is used to control the W1, passive W2 and

passive W3 when operating either as stand-alone full-range systems or with

additional WS2 sub-bass enclosures.

It is also used to provide the outputs for other WX3A controllers configured

to drive active W2 and W3 systems used in stereo with WS2 sub-bass

enclosures.

PCB mounted jumper links on the plug-in board select various alignment

options for the full-range/high pass outputs (Bands 2 and 4). See Fig 6.

Fig. 6

If full-range mode (1) is selected, +6dB of low frequency boost at 65Hz is

applied to the full-range outputs (Bands 2 & 4).

If 100Hz high-pass crossover mode (2) is selected, the full-range outputs

are re-configured as 100Hz high-pass outputs.

In Overlap Mode (3), the sub-bass and full-range enclosures are allowed to

overlap and 3dB of LF boost is applied to the full-range enclosure. This

can be useful when the full-range systems are flown some distance from

the sub-bass. This mode allows some low frequency energy to be

reproduced by the flown loudspeakers without using up as much headroom

as would be required if the full-range +6dB low frequency boost were

applied.

Martin Audio – WX3A System Controller

ENGLISH

Mode 1

Mode 2

Mode 3

CONTENTS

GUIDES

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Keine Kommentare

Martin Audio W3 Spezifikationen Seite 8